Why slurry pump vibration and noise?

Slurry pump vibration and noise

1) Uneven media density
Uneven density of the medium caused by the pump just start will appear vibration
When the pump is normally turned on, the pump vibration will disappear.
This situation does not need to deal with, just before driving, pay attention to the medium with high pressure wind blowing uniform.

2) pump cavitation, so that the impeller is not balanced
Should be adjusted to reduce the outlet valve, reduce the installation height, reduce the inlet resistance.

3) Pump installation is not horizontal.

Pay attention to the level of the pump body in the installation process, and pay attention to the usual inspection.

4) Uneven intake air of suction pipe
Reinforce the uniform stability of air intake to improve pump feeding.

5) Large pump (motor) bearing clearance
Bearing clearance will lead to large pump vibration, in the daily inspection of the equipment, pay attention to observe at any time the pump, found that the pump shaft and motor shaft is not concentric or bearing damage should be dealt with in time.

If you need to buy the right water well drilling rig, click the link below to contact our professional team.

Contact us

Comments

What are the differences bewteen core drilling bits and pdc drilling bits

Although both core drills and PDC drills are tools used for drilling and sampling, there are significant differences between them in terms of material, structure, and scope of application. Core Drill Definition: A core drill is a broad concept that refers to all drills used for coring operations. It can be a variety of types such as tungsten carbide bits, PDC bits, diamond bits and so on. Function: Mainly used to remove a cylindrical section of core sample from different types of materials for subsequent analysis and research. Material: Various materials, including carbide, diamond, PDC, etc. Different materials are selected according to the hardness and toughness of the drilling material. Structure: Relatively simple structure, mainly consists of drill body, inner cylinder and outer cylinder. Application: Wide range of applications, including geological exploration, engineering survey, mineral exploration, etc. PDC Drill Bit Definition: PDC drill bit is a special coring dr...

Does the water well drilling bit have a warranty

Whether or not a water well drill bit has a warranty, and the length of that warranty, depends on several factors: Drill Bit Type: Different types of drill bits vary greatly in their structure, material and manufacturing process, and therefore warranty policies will vary. For example, PDC bits (polycrystalline diamond composite bits) usually have a longer warranty due to their higher technology, whereas some simple tooth wheel bits or diamond bits may not have a defined warranty or may have a shorter warranty. Manufacturer/Supplier: After-sales service policies and reputations vary between manufacturers or suppliers. Some large, reputable manufacturers usually offer a good warranty, while some small, unknown suppliers may not offer a warranty or may have harsh warranty terms. Purchase Contracts/Agreements: When purchasing a drill bit, it is important to read the terms of the purchase contract or agreement carefully, especially the sections on warranty and after-...

How to replace the impeller of a slurry pump

The impeller of the slurry pump is a wearing part, which needs to be inspected and replaced periodically. The process of replacing the impeller is relatively complex and requires certain specialized knowledge and skills. The following are the steps for replacing the impeller of the slurry pump: 1. Preparation Shut down and disconnect the power: Before any operation, be sure to cut off the power supply to ensure safety. Preparation tools: ready wrenches, screwdrivers, gaskets, new impeller and so on. Drain: Empty the pump. Protective measures: Wear protective gloves, safety glasses and other protective equipment. 2. Disassembly Procedure DISASSEMBLY: Disassemble the suction and discharge pipes connected to the pump. Remove pump cover: Loosen the bolts securing the pump cover and carefully remove the cover. Remove the impeller: Loosen the nuts secure the impeller with a suitable tool and remove the impeller. 3. Install the new impeller Insp...

Pearldrill PDC Bits and Pumps

Search This Blog